
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
15) Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
16) Avoid improper installation and never position the unit where good ventilation is impossible. When
installing this TV, distance recommendations must be maintained between the set and the wall,
as well as inside a tightly enclosed area or piece of furniture. Keep to the minimum distance
guidelines shown for safe operation.
200 mm
17) Cautions for installation
-- Do not tilt the TV towards the left or right, or towards the back.
-- Install the TV in a corner on the floor so as to keep cords out of the way.
-- The TV wil! generate a slight amount of heat during operation. Ensure that sufficient space is
available around the TV to allow satisfactory cooling.
FCC Notice:
Note: This equ*pment has been tested and found to comply with the limits for a Class B
digital dewce, pursuant to Par[ 15 of the FCC Rules. These hm_ts are designed to provide
reasonable protechon against harmful interference in a residential installation. This
equipment genera[es, uses and can radiate radio frequency energy and, if net installed
and used in accordance with the instructions, may cause harmful interference to radio
commun_cabons. However there _sno guarantee that interference will not occur m a
particular installation. If this equlpmem does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on the user ]e
encouraged to try to correct the interference by one or more of the follow_ng measures:
- Reorient or relocate the receiving antenna.
- Increase the separahen bet /een the equipment and receiver.
- Connect the equipment into ar outlet on a c_rcu_tdifferent from that to which the receiver is
connected.
- Consult the dealer or an experienced radiolTV technician for heip.
II
Comentários a estes Manuais