DRAKE SRR60 Instruções de Operação descarregar pdf (Página 12)

12 Battery Installation & Charging

Battery Preparation (batteries from retail source)

For both the HHM60 Hand Held Microphone, and the

BP60 Belt Pack, it will be necessary to remove

approximately 1/2 inch of insulation from the nega-

tive end of one of the two batteries which will be

installed in each unit. This must be done so that the

CHARGE CONTACTs will make contact with them.

This is shown in the following photo.

Insulation Removed from negative end

Installation in BP60 Belt Pack

Insert a “AA” size Ni-MH rechargeable battery with

the insulation removed as shown above, in the BP60

battery compartment location containing the

CHARGE CONTACT, observing the polarity as

shown below.

Then insert the other battery, again observing the

polarity. Note that it is not necessary to remove the

insulation from the negative end of the second

battery. See the following photo.

Using the ADJUSTMENT TOOL, set the LO HI

switch to LO (left), the CHANNEL SWITCH to CH 1

(left) and set the MIC.GAIN control to approximately

50% of its rotation.

Then return the ADJUSTMENT TOOL to its storage

location, replace the battery compartment cover, and

connect the battery charger to the CHG connector.

Make sure that the POWER switch is off.

Plug the charger into a 120 VAC 60 HZ power

source and allow the unit to charge for approxi-

mately 12 hours.

Installation in HHM60 Hand Held Microphone

Insert a “AA” size rechargeable battery with the

insulation removed (as shown opposite) in the HH60

battery compartment location with the CHARGE

CONTACT, observing the polarity as shown below.

CHARGE CONTACT

Then insert the other battery, observing the polarity.

Note that it is not necessary to remove the insulation

from the negative end of the second battery. See

the following photo.

Set the LO HI switch to LO (down) and set the

CHANNEL SWITCH to CH 2 (down). See the

following photo.

Replace the battery compartment sleeve by screw-

ing it on, rotating it clockwise until snug.

Make sure that the POWER SWITCH is off.

Then connect the battery charger to the CHARGING

CONNECTOR, located on the bottom of the unit.

(See item 2, page 11.) Plug the charger into a 120

VAC 60 Hz power source and allow the unit to

charge for approximately 12 hours.

CHANNEL SWITCH to

CH 2 (down)

LO HI switch to LO

(down)

IMPORTANT!

DO NOT ATTEMPT TO CHARGE ALKALINE,

CARBON ZINC, OR NICKEL CADMIUM BATTER-

IES!

Adjustment

Tool

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

DRAKE SRR60 Instruções de Operação Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor DRAKE SRR60